Powering Up the Unit
- After installing your SecureSync unit, and connecting all references and network(s), verify that power is connected, and wait for the device to boot up.
- Observe that the front panel illuminates The time display will reset and then start incrementing the time.
Note: SecureSync does not have a power switch. When the unit is plugged in, the power will be on
- Check the front panel status LED indicators:
- The Power LED should be lit (not flashing).
- The GNSS LED will be either OFF or flashing HEARTBEAT, since synchronization has not yet been achieved.
- The Alarms LED light should be OFF (startup behavior) or HEARTBEAT (acquiring fix behavior). A FAST blinking pattern would indicate the unit requires attention.
SecureSync front panel
For additional information, see Status LEDs and Status Monitoring via Front Panel.