SOURce:ONECHN:SIGNALtype
Function
Sets signal(s) to be simulated (use this command only while the unit is not generating any RF). Signal type consists of comma separated list of signal names, as described under “Parameters” below.
Command Syntax
SOURce:ONECHN:SIGNALtype <string>
Notes
The satellite system GPS/GLONASS/GALILEO, BeiDou/QZSS/IRNSS and the modulation (signal mode) are set with the SOURce:ONECHN:satID
command.
In firmware versions before version 7.0.1 if requested signal types were not compatible with the satellite ID selected either by the SOURce:ONECHN:satID
command or from the front panel those signals were ignored and not set. As of firmware version 7.0.1 any incompatible signal results in whole command failure so that no signal is set.
Parameters
-
<String>
– GPSL1CA,GPSL1P,GPSL1PY, GPSL2P,GPS L2PY for GPS -
<String>
– GLOL1,GLOL2 for GLONASS -
<String>
– GALE1,GALE5a,GALE5b for Galileo -
<String>
– BDSB1, BDSB2 for BeiDou -
<String>
– QZSSL1CA, QZSSL1SAIF, QZSSL2C, QZSSL5 for QZSS -
<String>
– IRNSSL5 for IRNSS
Example
SEND:
SOURce:ONECHN:SIGNALtype GPSL1CA,GPSL2P
SEND:
SOURce:ONECHN:SIGNALtype GPSL1CA,GLOL2