You Are Here:

SOURce:SCENario:POWer

Function

Set the power of satellite satID when scenario is running. Freqband parameter is optional and can be used when only certain frequency band power of satellite is changed. Value ALL in freqband means that power of all bands are adjusted by the amount indicated by the command.

Command Syntax

SOURce:SCENario:POWer ON|OFF
SOURce:SCENario:POWer <satID>,<decimal>[,<freqband>]
SOURce:SCENario:POWer <satID>, ON|OFF
SOURce:SCENario:POWer <SatSystem>, ON|OFF
SOURce:SCENario:POWer <SatSystem>,<decimal>[,<freqband>]

Note

Only available during scenario execution.

Parameter

Decimal [-160.0,-65.0] dBm, if freqband is not ALL. For ALL, the relative change by which the power setting is to be modified, should be limited to a delta of 100 (e.g., changing a power of -65 dBm to -165 dBm (by -100) and vice-versa (+100).

For a list of satID satellite identifier, see SOURce:ONECHN:SATid?.

FreqBand [L1, L2, L5, ALL]. If the freqband is not specified, it is assumed to be L1.

Examples

SOURce:SCENario:POWer E7, -100
  • Sets power of L1 freqbands of satellite E7 to -100 dBm
SOURce:SCENario:POWer G23,-75, ALL
  • Sets power of all freqbands of satellite G23 to -75 dBm
SOURce:SCENario:POWer R22,-115, L1
  • Sets power of L1 freqbands of satellite R22 to -120 dBm
SOUR:SCEN:POW GPS,-120, L5
  • Sets power of all GPS L5 channels to -120 dBm
SOUR:SCEN:POW GLO,OFF
  • Turns off power of all GLONASS satellites
SOUR:SCEN:POW GAL,ON
  • Turns on power of all Galileo satellites, absolute power is restored to the level it had before it was turned off