You Are Here:
You are here: SCPI Guide > Command Reference > Source Subsystem > SOURce:ONECHN:LOSDynamics:CONTrol

SOURce:ONECHN:LOSDynamics:CONTrol

Function

Starts, restarts or stops the line of sight dynamics profile. This command can only be used while RF is generated. Before starting the profile its parameters must be set using the SOURce:ONECHN:LOSDynamics:SETtings command.

After the profile is started, the Doppler frequency shift is controlled automatically and can neither be changed using the SOURce:ONECHN:FREQuency command, nor via the front panel.

Command Syntax

SOURce:ONECHN:LOSDynamics:CONTrol <START|STOP>

Parameters

<START> – starts line of sight dynamics profile if the profile is not running or restarts the profile applying new parameters

<STOP> – stops line of sight dynamics profile

Example

SOUR:ONECHN:LOSD:CONT START