You Are Here:
You are here: SETUP > Configuring NTP > Dis-/Enabling NTP

Dis-/Enabling NTP

If you applied NTP configuration changes e.g., added a new NTP Server, NetClock usually will stop and re-start the NTP Service automatically once you clicked Submit. Changes made to NTP configurations will also take effect after NetClock is either rebooted or power-cycled.

You can, however, also disable or enable the NetClock NTP Service manually, e.g. with NTP Autokey.

To disable and enable your NTP Service:

  1. Navigate to MANAGEMENT > NETWORK: NTP Setup.
  2. In the NTP Services panel, set the ON/OFF toggle switch to OFF.
  3. A notification window will confirm the status change.
  4. In the NTP Services panel, set the ON/OFF toggle switch to ON again.

Changes made will now take effect and NTP operation will be restored shortly after this operation is performed.