PCI-104 Configuration (DIP Switch)
The max configuration for the PCI bus of PCI-104 modules is FOUR plus the host board. When stacking more than one PCI-104 module to a host board, the modules need to be set to different PCI numbers, using the DIP switch SW1.
Follow the installation procedure outlined under PCI-104: Card Installation.
DIP-switch layout
SW1 Settings [(*) = default]
Switch 1 | Switch 2 | Module Slot | INT # selected |
---|---|---|---|
OFF (*) | OFF (*) | 1 | INT A#/CLK 0/IDSEL 0 |
OFF | ON | 2 | INT B#/CLK 1/IDSEL 1 |
ON | OFF | 3 | INT C#/CLK 2/IDSEL 2 |
ON | ON | 4 | INT D#/CLK 3/IDSEL 3 |