You Are Here:
You are here: MANAGING TIME > Managing References > The GNSS Reference > Resetting the GNSS Receiver

Resetting the GNSS Receiver

The Reset Receiver command causes the GNSS receiver to execute a cold start: All data will be erased from the volatile receiver memory. Only non-volatile memory is preserved.

Caution: Resetting the GNSS receiver may become necessary in the rare event of internal communication issues, and is typically ONLY required if Spectracom Technical Support advises you to execute this command.

Note that resetting the GNSS receiver is not the same as Deleting the GNSS Receiver Position.

To reset the GNSS Receiver:

  1. Navigate to Interfaces > References: GNSS Reference
  2. Click on the GEAR button next to the GNSS Reference. The GNSS 0 window opens:
  3. Locate the Reset Receiver box, check it, and click Submit.