Configuring Inputs/Outputs

This Section covers the configuration of the inputs and outputs of the I/O connector and SMA connectors on the front panel..

When you configure an input our output via the I/O connector, you will need to adjust both the pin configuration (Assigning I/O Pins) and (for some types) the settings for that input or output via the Web UI (Configure I/O Settings).

I/O connector

For more information on the I/O connector, see Connectors and their Pinouts.

Note: For instructions on how to configure the GNSS input reference, see The GNSS Reference in the Chapter MANAGING TIME.

Note: The Network Ports eth0 and eth1 can be configured under MANAGEMENT > Network Setup. For more information, see Configuring Network Settings.

 

Select a topic  >>>>>>>>>>>>>>>>>>